Interface
Connecting to armed response radio
Interface V2 positive trigger No special app settings Interface V1 positive trigger App settings: O1 - O8 Mode: O1 - O5 Alarm O1 - O8 Polarity: N/C All sensors must be set to Zone 1 Interface V1 & V2 negative trigger App settings: O1 - O8 Mode: O1 - ...
Connecting an Armed status LED indicator
Below the wiring diagram for a status LED without a built-in resistor. Most Armed status LED indicators purchased from alarm retailers has a built-in resistor, the positive wire can then be connected to positive 12V without the resistor.
Wiring to an existing alarm panel
The outputs on the Interface unit are connected to the alarm system panel inputs. When the wireless sensor sends an alarm signal, the Interface unit processes the signal and opens (by default, the output can be also set for closing) the wire output ...
Installing a Siren or LED spot light
The relay on the module can be used to connect additional sirens, lights etc. to the KwêBeam system. The relay will activate when an Alarm signal is received while the system is armed. A Panic signal will also trigger the relay if O8 is set NOT to ...
Remote receiver to Arm/Disarm the Kwêbeam system
A remote receiver can be connected to the (IN) input to Arm & Disarm the KwêBeam system. The input can be programmed to accept a Pulsed or Lathed signal. Panic can also be wired in if you have a dual channel receiver.
Monitor external devices for Alarm and Tamper signals
The optical input can be programmed to report Alarm, Tamper or Panic signals when triggered. Use this input to monitor Alarm & Tamper events on electric fence energizers, gate motors, alarm systems etc. The input can also be programmed to have a ...
How to pair Interface
Connect 12V to the + and - of the interface. Open the App, click the green right arrow next to your system and click on devices. Press the big plus button and enter a name and zone number. When you press on confirm, the interface will start to flash ...